The Soviet Union launched Sputnik 1 in 1957. The spherical metal satellite carried a radio transmitter and sent signals back to Earth through its antennas.
Its journey around Earth demonstrated that a human-made object could enter orbit. Its radio signals became one of the most recognizable sounds of the early space age.
Design
The chief constructor of Sputnik 1 at OKB-1 was Mikhail S. Khomyakov. The satellite was a 585-millimetre (23.0 in) diameter sphere, assembled from two hemispheres that were hermetically sealed with O-rings and connected by 36 bolts. It had a mass of 83.6 kilograms (184 lb). The hemispheres were 2 mm thick, and were covered with a highly polished 1 mm-thick heat shield made of an aluminium–magnesium–titanium alloy, AMG6T. The satellite carried two pairs of antennas designed by the Antenna Laboratory of OKB-1, led by Mikhail V. Krayushkin. Each antenna was made up of two whip-like parts, 2.4 and 2.9 metres (7.9 and 9.5 ft) in length, and had an almost spherical radiation pattern.
The power supply, with a mass of 51 kg (112 lb), was in the shape of an octagonal nut with the radio transmitter in its hole. It consisted of three silver-zinc batteries, developed at the All-Union Research Institute of Power Sources (VNIIT) under the leadership of Nikolai S. Lidorenko. Two of these batteries powered the radio transmitter and one powered the temperature regulation system. The batteries had an expected lifetime of two weeks, and operated for 22 days. The power supply was turned on automatically at the moment of the satellite's separation from the second stage of the rocket.
The satellite had a one-watt, 3.5 kg (7.7 lb) radio transmitting unit inside, developed by Vyacheslav I. Lappo from NII-885, the Moscow Electronics Research Institute, that worked on two frequencies, 20.005 and 40.002 MHz. Signals on the first frequency were transmitted in 0.3 s pulses (near a frequency of 3 Hz) (under normal temperature and pressure conditions on board), with pauses of the same duration filled by pulses on the second frequency. Analysis of the radio signals was used to gather information about the electron density of the ionosphere. Temperature and pressure were encoded in the duration of radio beeps. A temperature regulation system contained a fan, a dual thermal switch, and a control thermal switch.
Launch and mission
The control system of the Sputnik rocket was adjusted to an intended orbit of 223 by 1,450 km (139 by 901 mi), with an orbital period of 101.5 minutes. The trajectory had been calculated earlier by Georgi Grechko, using the USSR Academy of Sciences' mainframe computer.
Several engines did not fire on time, almost aborting the mission. A fuel regulator in the booster also failed around 16 seconds into launch, which resulted in excessive RP-1 consumption for most of the powered flight and the engine thrust being 4% above nominal. Core stage cutoff was intended for T+296 seconds, but the premature propellant depletion caused thrust termination to occur one second earlier when a sensor detected overspeed of the empty RP-1 turbopump. There were 375 kg (827 lb) of LOX remaining at cutoff.
Reception
Organised through the citizen science project Operation Moonwatch, teams of visual observers at 150 stations in the United States and other countries were alerted during the night to watch for the satellite at dawn and during the evening twilight as it passed overhead. The USSR requested amateur and professional radio operators to tape record the signal being transmitted from the satellite. One of the first observations of it outside of the Soviet Union was made at the school observatory in Rodewisch (Saxony).
News reports at the time pointed out that "anyone possessing a short wave receiver can hear the new Russian earth satellite as it hurtles over this area of the globe. Directions, provided by the American Radio Relay League, were to "Tune in 20 megacycles sharply, by the time signals, given on that frequency. Then tune to slightly higher frequencies. The 'beep, beep' sound of the satellite can be heard each time it rounds the globe. The first recording of Sputnik 1's signal was made by RCA engineers near Riverhead, Long Island. They then drove the tape recording into Manhattan for broadcast to the public over NBC radio. However, as Sputnik rose higher over the East Coast, its signal was picked up by W2AEE, the ham radio station of Columbia University.
